R3VLimited Forums

Go Back   R3VLimited Forums > E30 Technical Forums > 325iX Technical and Discussion

Reply
 
Thread Tools Search this Thread
Old 05-27-2019, 08:20 AM   #1
Steiner
Member
 
Join Date: Oct 2018
Location: Bloomfield Hills, MI
Posts: 47
Installing Rear Driveshaft - Too Long?

Iím in the process of installing a new rear driveshaft, but it seems too long to get over the centering pin at the transfer case. The clamping nut appears to be loosened all the way (up against front section - no threads visible).

Any suggestions? I tried putting the flex disc on the shaft first, then attached the shaft to the final drive before attempting to get it up over the center pin.

Thanks!


Sent from my iPhone using Tapatalk
__________________
1991 325ix Coupe 5 Speed
1990 325ix Sedan Auto
2001 M3 Convertible 6 Speed
+2002 M3 Convertible SMG (RIP)
1972 Ford Bronco

Instagram: @steine20
Steiner is offline   Reply With Quote
Old 05-27-2019, 08:47 AM   #2
Steiner
Member
 
Join Date: Oct 2018
Location: Bloomfield Hills, MI
Posts: 47
Iím an idiot -the sleeve wasnít loosened all the way, it was tightened all the way. Good to go now.


Sent from my iPhone using Tapatalk
__________________
1991 325ix Coupe 5 Speed
1990 325ix Sedan Auto
2001 M3 Convertible 6 Speed
+2002 M3 Convertible SMG (RIP)
1972 Ford Bronco

Instagram: @steine20
Steiner is offline   Reply With Quote
Old 05-28-2019, 08:34 AM   #3
The Dark Side of Will
R3VLimited
 
Join Date: Jun 2010
Location: VA
Posts: 2,557
Lol. Congrats?
The Dark Side of Will is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 03:49 PM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright 2004 - 2020 R3VLimited LLC