If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Discover the magic of the internet at Imgur, a community powered entertainment destination. Lift your spirits with funny jokes, trending memes, entertaining gifs, inspiring stories, viral videos, and so much more from users.
I'm working on an MS3 install and I got a set of nice Bremi coils from the junkyard today. Is this wiring diagram pretty much correct? I don't want to accidentally fry a coil.
Also sorry for the imgur link; I can't seem to get embedding to work.
Followup:
Yes, this is correct. Fiddled with it and got a plug to fire with an arduino and a MOSFET. Coil fires when you pulse ground to the signal wire. Probably one of those "don't think about it too hard if it works" situations, but I like understanding stuff.
Also realized this is probably in the complete wrong board. Oops.
Comment