Announcement

Collapse
No announcement yet.

2.5" stainless rear exhaust section

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    2.5" stainless rear exhaust section

    I had Arc Asylum make this for me as a part of a whole exhaust for my s54 swap and I pulled it out because it was too loud for my taste. I'm building a quiet daily driver. I'm sure someone would love this on their car. Great looking welding from Tyler!

    I believe but can't confirm that these are magnaflow pieces (resonator and muffler). Everything is 2.5" and it has a slipfit with clamps on the front as well as for the tip so you can fit it in place perfectly.
    SOLD

    Only 100 miles on it...





    Last edited by rjmcdermott81; 10-23-2017, 02:27 PM.
    Build Thread: Ryan's Hennarot 318is
    COTM Aug 2019

    #2
    How long is this? It seems like it would hit the rear subframe/axle unless it dips down
    Originally posted by LJ851
    I programmed my oven to turn off when my pizza was done, should i start a build thread?

    Feedback

    Comment


      #3
      Originally posted by chadthestampede View Post
      How long is this? It seems like it would hit the rear subframe/axle unless it dips down
      It would have been smart if I had taken a picture with it mounted but I didn't. This mounts behind the rear subframe so it's pretty short. I'll take a pic holding it up tomorrow.

      Cleared really nicely.
      Build Thread: Ryan's Hennarot 318is
      COTM Aug 2019

      Comment


        #4
        Pics showing length:







        Build Thread: Ryan's Hennarot 318is
        COTM Aug 2019

        Comment


          #5
          PM sent, I'll take it.
          1990 Brilliantrot 325iS Build Thread
          1989 Zinnoberrot M3 Build Thread

          Comment

          Working...
          X