Pressurized as in combustion gasses from the cylinders are leaking into the cooling system and "over-pressurizing" it to the point that hoses pop off (or are extremely hard when running). Basically if the head gasket has a slight leak onto the cooling system, every time that piston comes up, it leaks pressure into the system. A cooling system runs at about 16psi-21psi, a running engine combustion chamber will see in the neighborhood of 200psi at idle/cranking.
Announcement
Collapse
No announcement yet.
S52 w/ AC cooling problems
Collapse
X
-
Originally posted by ForcedFirebird View PostPressurized as in combustion gasses from the cylinders are leaking into the cooling system and "over-pressurizing" it to the point that hoses pop off (or are extremely hard when running). Basically if the head gasket has a slight leak onto the cooling system, every time that piston comes up, it leaks pressure into the system. A cooling system runs at about 16psi-21psi, a running engine combustion chamber will see in the neighborhood of 200psi at idle/cranking.
Comment
-
Originally posted by ATL_E30 View PostAny luck?
Comment
-
Originally posted by Strelok View PostPut about 20 miles on it after tightening the hose, refilling and bleeding. Temp gauge hangs out just under 1/2 and hasn't touched 3/4 in stop and go. It hasn't been quite as hot this past week so it still needs more testing but I think it's good to go
Comment
-
FYI, I've only got the stock AC condenser fan in my M50 powered E34 (no mechanical fan) with a mishimoto E36 radiator and a Stewart high performance water pump. With the AC on full blast in 90ยบ weather, the temp never creeps up past half. I did also get a fan switch from an M42 powered car (lower temp).
Comment
-
So, interesting new development. The car has been running great, no overheating, but I realized the other day that my aux fan went out. On closer inspection, the zipties that were holding the low speed resistor in place have melted off, and the high speed fuse was blown. I'm guessing this resistor has gone out. Any thoughts on whether this is just a wear item or do I maybe need a different on to deal with the SPAL fan over stock?
Comment
-
Stock is better. The resistors do fail on these cars... I'd say this is a "wear" item.IG: deniso_nsi Leave me feedback here
Comment
Comment