Swapped a S50 into my car paired with a M42 radiator. My temp gauge worked before the swap just fine. Got the engine going and it looked like the gauge wasn't moving even though the car was getting plenty hot. Swapped out temp sensors (even though I had an E30 temp sensor in there to begin with), and it began to work.
I tried to bleed my coolant to no avail because I ran out of time. Let the car sit overnight and then I tried to bleed my coolant again but my temp gauge wasn't working again! I checked that I had continuity from the sensor plug all the way to C101 so it's not my wiring harness. Could there be an air bubble so big that it's preventing my temp gauge from working? I have been having bleeding issues after all.
Yes I've smacked the dash ;)
I tried to bleed my coolant to no avail because I ran out of time. Let the car sit overnight and then I tried to bleed my coolant again but my temp gauge wasn't working again! I checked that I had continuity from the sensor plug all the way to C101 so it's not my wiring harness. Could there be an air bubble so big that it's preventing my temp gauge from working? I have been having bleeding issues after all.
Yes I've smacked the dash ;)
Comment