So I did my best to even out the gaps on my hood and trunk but the panel alignment is still a little wonky.
The trunk is edged over to the left a little, but if I try to slide it over, it tends to stick out on the back on one side
I also adjusted the hood so the gap is even, but unfortunately this has lead to one side of the hood being more forward of the grille than the other
It doesn't look like the car has been seriously impacted (except for a love tap that pushed he bumper and rear Panel in slightly) as all the panels look like they contain the original tags.
Is it possible the hood and trunk are warped or bent causing this or is it more likely the unibody is tweaked? Car goes down the road straight and doesn't seem off.
Just looking for suggestions on what I can do to fix this, if anything. The car is my daily so it's far from pristine, but I'd like to get it looking the best I can.
Sent from my iPhone using Tapatalk
The trunk is edged over to the left a little, but if I try to slide it over, it tends to stick out on the back on one side
I also adjusted the hood so the gap is even, but unfortunately this has lead to one side of the hood being more forward of the grille than the other
It doesn't look like the car has been seriously impacted (except for a love tap that pushed he bumper and rear Panel in slightly) as all the panels look like they contain the original tags.
Is it possible the hood and trunk are warped or bent causing this or is it more likely the unibody is tweaked? Car goes down the road straight and doesn't seem off.
Just looking for suggestions on what I can do to fix this, if anything. The car is my daily so it's far from pristine, but I'd like to get it looking the best I can.
Sent from my iPhone using Tapatalk