I installed some Garagistic derlin shift bushings, pushed them in as much as possible, use a c-clamp too.
I put the rear carrier through the hole but haven't tighted the nut yet.
The arm does not want to go back into the transmission, its a really tight fit. Do you have to shave these down at all before the install? The few install videos I can find seem to just show the arm popping right in.
The hole that the bitch clip goes into seems super tight as well, how will that pin get pushed back in with such a tight clearance? I dropped the transmission a little bit, but haven't disconnected the driveshaft .
Update: I have it a third of the way in by jacking the transmission up a bit to use the trans-tunnel to push it in.
I put the rear carrier through the hole but haven't tighted the nut yet.
The arm does not want to go back into the transmission, its a really tight fit. Do you have to shave these down at all before the install? The few install videos I can find seem to just show the arm popping right in.
The hole that the bitch clip goes into seems super tight as well, how will that pin get pushed back in with such a tight clearance? I dropped the transmission a little bit, but haven't disconnected the driveshaft .
Update: I have it a third of the way in by jacking the transmission up a bit to use the trans-tunnel to push it in.
Comment