Hi guys, first post.
I'm gathering parts for my manual swap while in the middle of rebuilding my cylinder head, and fixing all the screw-ups from the previous owner who "fixed 'er up."
With my introduction over, now for the question. When I resurfaced my flywheel on the lathe, I forgot to measure and re-machine the step between the clutch friction surface. The flywheel is a single mass and I'm using a Sachs clutch kit. Would anybody happen to know what the step height is? If not, I'll machine it to .050" as that's what it looked like.
Picture: https://www.instagram.com/p/Bee1eNGh...en-by=325e_e30
Andre
I'm gathering parts for my manual swap while in the middle of rebuilding my cylinder head, and fixing all the screw-ups from the previous owner who "fixed 'er up."
With my introduction over, now for the question. When I resurfaced my flywheel on the lathe, I forgot to measure and re-machine the step between the clutch friction surface. The flywheel is a single mass and I'm using a Sachs clutch kit. Would anybody happen to know what the step height is? If not, I'll machine it to .050" as that's what it looked like.
Picture: https://www.instagram.com/p/Bee1eNGh...en-by=325e_e30
Andre
Comment