If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I could use a the passenger side interior door handle, the convertible top boot-lid handle, and the passenger side latch that holds the top down if you have them and they're not broken yet.
sigpic
1987 - 325i Convertible Delphin Auto [SOLD], 325i Convertible Delphin Manual [SOLD]
1989 - 325i Convertible Bronzit m30b35 swapped [SCRAPPED], 325i Sedan Alpine Auto[DD]
1991 - 325i Coupe Laguna Manual [Project], 535i Sedan Alpine [SCRAPPED]
I can be in touch if you guys are curious. His shop just closed, so it might be hard to track him down, but he's in my area.
When I looked at it, it was being parted because the rear subframe was bent. Looked like it had been hit on the back left. Body panels were semi-straight. I didn't get to look at the interior because I was looking for a hood.
I could use a the passenger side interior door handle, the convertible top boot-lid handle, and the passenger side latch that holds the top down if you have them and they're not broken yet.
My boot lid handle broke as well. Is it not the same part as the interior door handle, just upside down?
It is the same as the passenger door handle, but upside down. It will also have a grommet on this that can unscrew. This is used to hold the cables that release the bootlid.
sigpic
1987 - 325i Convertible Delphin Auto [SOLD], 325i Convertible Delphin Manual [SOLD]
1989 - 325i Convertible Bronzit m30b35 swapped [SCRAPPED], 325i Sedan Alpine Auto[DD]
1991 - 325i Coupe Laguna Manual [Project], 535i Sedan Alpine [SCRAPPED]
Comment