If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
First, I ended up throwing a second 8HP45 in my car because the first was making a noise under load that sounded like dry bearings in sand. All gears, only...
The GS6-17 was well-matched with a 3.15. The E90's had a 3.23 so considering that my tires circumference is 9% smaller it's within a few percent of a stock E90, about 5% shorter. A 2.93 would basically...
Making progress... The shaft splne and the rear cap to the shaft housing are being printed, plus I got a 2nd $25 column as my "actual" one. (much more careful not to get cutting grit in the...
Leave a comment: