So a little confused about my Konis... Not much install info out there and the stupid instructions are all cryptic :p
The collar will only thread down this far
It bottoms out on the body of the insert
I'm wondering if that's what it's referring to here under III, it says up to 1-4mm gap?
I'm thinking of just cutting down the collar piece to fit...
Side note but is it referring to antifreeze or cold water or something on the top left of that diagram?
The collar will only thread down this far
It bottoms out on the body of the insert
I'm wondering if that's what it's referring to here under III, it says up to 1-4mm gap?
I'm thinking of just cutting down the collar piece to fit...
Side note but is it referring to antifreeze or cold water or something on the top left of that diagram?
Comment