FS:E30 and E21 rear Euro bumper projects. I am asking $100.00 each
E30 bumper - Good ends (minor dings, but not bad), center section has a slight bend and surface rust on back side. There is no hardware nor are there any mounting brackets except for the joint cover plates that are fair at best. The impact strip is available, but has a decent rip in it. These parts would be best suited for a paint job, though I think the ends could be re-plated. Bumper has been disassembled for shipping. This would make a fine bumper for a daily driver!
E21 bumper - The best parts are the ends (slightly bent) and the impact strip. I got the strip off with the mounting studs intact also. There is no hardware nor are there any mounting brackets except for the joint cover plates that are fair at best. The center is bent and rusty if you want it. Bumper has been disassembled for shipping.
Note: E21 bumper ends look to be the correct length for 88+ cars (facelift) and would look cool with some custom sheet metal work below them.
E30 bumper - Good ends (minor dings, but not bad), center section has a slight bend and surface rust on back side. There is no hardware nor are there any mounting brackets except for the joint cover plates that are fair at best. The impact strip is available, but has a decent rip in it. These parts would be best suited for a paint job, though I think the ends could be re-plated. Bumper has been disassembled for shipping. This would make a fine bumper for a daily driver!
E21 bumper - The best parts are the ends (slightly bent) and the impact strip. I got the strip off with the mounting studs intact also. There is no hardware nor are there any mounting brackets except for the joint cover plates that are fair at best. The center is bent and rusty if you want it. Bumper has been disassembled for shipping.
Note: E21 bumper ends look to be the correct length for 88+ cars (facelift) and would look cool with some custom sheet metal work below them.
Comment