Announcement
Collapse
No announcement yet.
P0101 Trouble code check engine light M52 swap
Collapse
X
-
I think both of those are bank two... Look there. Icv in the manifold all the way?
Check Us out on Facebook
Needing a harness adapter or wiring help? Check it out: also have 24v motor mounts, E30 M3 covers and E36 ECU mounts!
Full Product Line Tuning
OBD2 Tuning Available! OBD2 E36, S54 Swap, S62 Swap, etc: tuning@MarkertMotorWorks.com Dyno Thread
Comment
-
Need some more direction here:
I took the car in for a smoke test and too my surprise, the manifold was not leaking. However the valve cover was and it was pouring out smoke from coil six area. The shop told me I had a cracked valve cover. I just replaced the valve cover and gasket and am still getting the same 3 codes: P0170, P0173, and P1189. I also checked the old valve cover for cracks and cannot find even the slightest crack. Is there anything I am missing. I am assing I am still leaking from there with the new valve cover. What would cause the valve cover to leak so bad?
Comment
-
Just heard the results of the smoke test. The valve cover is pretty well sealed. Very light leaks that the mechanics said would likely not cause a problem. So, it looks like its sealed and without vacuum leaks. They said they tested one bank's O2 and it is lean and the other is rich. Said one O2 had the heat shield burnt off, but the 4 wires are all intact (which I had seen earlier), but that it was reading only 4volts. They want to look at it more on Monday, but should I just save the expense and pick up a couple new O2s and see if that fixes it? Almost everything else is new. The O2s were used so I could see if they are a problem.
Comment
-
What are your actual fuel trim #s?
Check Us out on Facebook
Needing a harness adapter or wiring help? Check it out: also have 24v motor mounts, E30 M3 covers and E36 ECU mounts!
Full Product Line Tuning
OBD2 Tuning Available! OBD2 E36, S54 Swap, S62 Swap, etc: tuning@MarkertMotorWorks.com Dyno Thread
Comment
-
woot!
Check Us out on Facebook
Needing a harness adapter or wiring help? Check it out: also have 24v motor mounts, E30 M3 covers and E36 ECU mounts!
Full Product Line Tuning
OBD2 Tuning Available! OBD2 E36, S54 Swap, S62 Swap, etc: tuning@MarkertMotorWorks.com Dyno Thread
Comment
Comment