I picked up a white 89 325ix a bit ago and the transfer case needed to be replaced, so I had it rebuilt here in town and I have it all hooked up to the front but the rear drive shaft has a small gap from it and the transfer case and I know next to nothing about cars so curious if anybody could help me out before i take it to a shop that would be awesome!, thanks in advance!
Announcement
Collapse
No announcement yet.
1989 325ix drive line help!!!!!
Collapse
X
-
The back of the driveshaft has a slip fitting. With the back of the driveshaft bolted to the diff, just grab it and push towards the t-case. It will extend.
Make sure the arrows on the guibo point towards the flanges and not the bolt heads
Sent from my iPhone using TapatalkThe best one-stop shopping for German car parts and lifestyle: http://www.gutenparts.com/
-
Pretty sure it isn't a threaded collar like rwd e30's. Should just slide fore and aft.
I just did it on mine last night to replace my gas tank.
See if you can find some longer m10 bolts. And pull the driveshaft onto the guibo by tightening the bolts. Then put the correct length bolts back in once the drivshaft is extended properly.
How did you collapse the drivshaft in the first place to get the t-case out?
Sent from my iPhone using TapatalkThe best one-stop shopping for German car parts and lifestyle: http://www.gutenparts.com/
Comment
Comment