I'm almost done with my guibo/CSB replacement, but something is wrong with the old driveshaft. It's like it is too short - the only way to install it is with the spline halfway out. Also the spline clamp that is supposed to hold the 2 pieces together doesn't seem to do anything.
I think my CSB is installed correctly... any ideas?
EDIT: There was no rubber/plastic piece inside of the spline clamp, just a toothed washer.
I think my CSB is installed correctly... any ideas?
EDIT: There was no rubber/plastic piece inside of the spline clamp, just a toothed washer.
Comment