If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
PS.
I have the reset tool and the GT1/SSS so I never do this but I think you can
ground pin #7 for 7-9 sec. and this will reset the oil change and if you hold it
to ground for 15sec. it will reset the service light...
aight ill have to call that place...as soon as I can get the car out...3 hours of digging to clear a 10x10 path...and open diff still sucks. At this point I miss my 240 with its cusco 2way.
A 1993 325ic should be an E36, but the procedure is similar on most BMWs. With the ignition off, put a wire between pins 7 and 19. Turn the ignition to position 2, 'run.' (Do not start the engine.) After just a couple seconds, remove the jumper wire. (If you wait eight to ten seconds, it will do an
Comment