Want a little more steering angle with out spending major $$ on modded knuckles? Not liking the idea of drilling out undersized or stacking smaller washers?
2014 edit: over 200 set sold since 2011~!!
Now offering 4.8mm($15 ) & 6mm spacers($18 ).
4.8mm thick~
1"o.d.
.75" i.d.
If you have searched what people run for thickness you'll know its generally 5mm. These being 4.8mm they have room too run the factory crush washer.
$15 per set shipped usps.
For those who do not know how these work: The spacers go in between the inner tie rod and steering rack and gives the steering rack more angle by furthering the racks push/pull. It is a good entry level mod to do for drifters. It will not give you quicker steering, just more angle.
You will have to adjust your outer tie rods inward the thickness of the spacer after installation for proper alignment.
;)
2014 edit: over 200 set sold since 2011~!!
Now offering 4.8mm($15 ) & 6mm spacers($18 ).
4.8mm thick~
1"o.d.
.75" i.d.
If you have searched what people run for thickness you'll know its generally 5mm. These being 4.8mm they have room too run the factory crush washer.
$15 per set shipped usps.
For those who do not know how these work: The spacers go in between the inner tie rod and steering rack and gives the steering rack more angle by furthering the racks push/pull. It is a good entry level mod to do for drifters. It will not give you quicker steering, just more angle.
You will have to adjust your outer tie rods inward the thickness of the spacer after installation for proper alignment.
Originally posted by Highway1
View Post
Finally got mine installed. Made a bigger difference than i thought. Thanks!
Not even close to full lock...
Sent from my EVO using Tapatalk 2
Not even close to full lock...
Sent from my EVO using Tapatalk 2
Originally posted by 6gen91
View Post
Finally got mine on with z3 rack
Originally posted by 328ijunkie
View Post
;)
Comment