GONE
Description: I am selling my 1987 BMW 325i (177k on the odometer)
It a completely rebuilt motor. Rebuilt head with new OEM cam.
Block was dipped, painted honed and has new freeze plugs and half shaft bearing was turned all done by Abacus racing.
Used a new set of pistons from a car with 70k miles.
SPEC Clutch w/ 20k miles
Flywheel resurfaced and balanced by Abacus
Mark D'sylva reflashed ECU programmed for 93 octane
e28 intake stretched to fit the m20
New front wheel bearings in box
New front lower control arms in box w/bushings
New tie rods and sway bar ends in box w/bushings
Energy two-piece poly control arm bushings
Poly engine mounts
New dashboard.
ATE performance brake rotors (front and back)
Ceramic brake pads
Has tokico shocks installed
Bilstien rear sport shocks in box.
Bavarian auto sport springs installed
Konig 17" wheels with good tires
***********
This car is currently not running due to no spark. I am at a loss as to what could be causing this. (New distrib. ignition coil and cps sensor.) I also just replaced the fuel pump and filter it needs the clutch slave cylinder put back on it(Have a brand new one in box. If I get the time I will do this.) I do not have the time to complete this project and
I already have a lot of money into this car.
The engine was taken apart and checked by a BMW specialist to make sure everything is in order.
Description: I am selling my 1987 BMW 325i (177k on the odometer)
It a completely rebuilt motor. Rebuilt head with new OEM cam.
Block was dipped, painted honed and has new freeze plugs and half shaft bearing was turned all done by Abacus racing.
Used a new set of pistons from a car with 70k miles.
SPEC Clutch w/ 20k miles
Flywheel resurfaced and balanced by Abacus
Mark D'sylva reflashed ECU programmed for 93 octane
e28 intake stretched to fit the m20
New front wheel bearings in box
New front lower control arms in box w/bushings
New tie rods and sway bar ends in box w/bushings
Energy two-piece poly control arm bushings
Poly engine mounts
New dashboard.
ATE performance brake rotors (front and back)
Ceramic brake pads
Has tokico shocks installed
Bilstien rear sport shocks in box.
Bavarian auto sport springs installed
Konig 17" wheels with good tires
***********
This car is currently not running due to no spark. I am at a loss as to what could be causing this. (New distrib. ignition coil and cps sensor.) I also just replaced the fuel pump and filter it needs the clutch slave cylinder put back on it(Have a brand new one in box. If I get the time I will do this.) I do not have the time to complete this project and
I already have a lot of money into this car.
The engine was taken apart and checked by a BMW specialist to make sure everything is in order.
Comment