FS: 1984 318i PNW

[KenC]

Very clean!! Free bump, hope it goes to a good home!

""Z4 3.0 Lever All bushings were replaced during installation"

I do have a question for you though since you looks like installed a z4 3.0 lever, did you have to do anything special to make it work/fit , do you still have the sheet metal console ? How is it, does the shifter hit the console in any gears including reverse ? I would really love to do this to mine but could not confirm if it really is a drop in upgrade like on the late e30s with a newer shifter console...

Definitely wasn't drop in. I had to use two of the lower cups stacked to get the lever to clear the driveshaft (no bending), and then I had to sand down part of the upper cup so that I could put the circlip in there. I didn't use the spring or hat when I put the Z4 lever in.

[KenC]

I didnt end up going to WA Ken. Call me.

I'll give you a ring tomorrow. I still have a few things left to do to the car (pull stereo being the biggest one). I've been running around all day today and haven't even sat down at my comp until now.

[Jean]

Definitely wasn't drop in. I had to use two of the lower cups stacked to get the lever to clear the driveshaft (no bending), and then I had to sand down part of the upper cup so that I could put the circlip in there. I didn't use the spring or hat when I put the Z4 lever in.

I was afraid to hear that. Sounds like I'll be ordering a new oem shifter rod and metal console instead...