Turbonetics T-Series 58/62 HP-58/F1-62 Ceramic Ball Bearing

[cokeisgood00]

Selling a Turbonetics T-Series 58/62 Single Ball Bearing turbo I bought from a member on BF.c. I have put less than 500 miles on this turbo. I ended up replacing this turbo because I thought there was a problem, but it turned out I had oil backing up in the drain causing oil smoke out the exhaust. When I got the new turbo I swapped the turbine housings, hence the different turbine than quoted below.

The pictures show two missing compressor backplate bolts. I have already ordered a new set and will put them in before shipping.

Located in Jacksonville, FL - Asking $750 OBO


Per the PO's for sale ad:

This has never been ran. It was custom built for 3-3.5 liter engine for fast spool and up to 550hp. It has .58 compressor side with 4 inch inlet and 2.5 inch out. 62 exhaust F1 design turbine from Turbonectics for fast spool but still upper hp range. Ball bearing and v band and t4 exhaust housing.

When I bought it, it came with a T4 inlet / 3.5Vband .58 AR turbine housing.

Compressor is a HP-58 (58mm) wheel
Turbine is a F1-62 (62mm) wheel

T series compressors have a 4" inlet / 2.5" outlet - this one has the anti-surge porting and a 90° outlet welded on.
Current turbine housing is T3 inlet - 0.85 AR - 4 bolt outlet

CHRA is oil cooled only

New this was $1750

See this link for the compressor map:
https://www.turboneticsinc.com/perfo...58_compmap.pdf

Full res photos: https://postimg.cc/gallery/q04pHkZ

[cokeisgood00]

bump make me an offer

[cokeisgood00]

bump lowered price $750