I have a brand new Sachs clutch kit for S14 (also fits M20 and M50 with M20 flywheel). The clutch disk, pressure plate, throwout bearing, and pilot bearing were all purchased brand new from Turner about 2 years ago. I ended up going with a different clutch/flywheel setup and never used this one. I also have a single mass M20 flywheel that I machined the back of to use on an M50 engine. The flywheel was almost brand new when I got it. It has a little surface rust on the friction surface but no pitting or anything. A simple sanding will clean it right up (or just run it, the clutch disk will clean it right up).
I paid $399 for the clutch kit and would like $325 shipped for the clutch kit and $150 shipped for the flywheel. Will combine for a shipping discount. Will also accept trades- large case (E28 or E30) 3.64 ish w/ LSD.
Contact info:
Email- lateapex31 'at' comcast 'dot' net
AIM: lateapex31
or message me through the PM system
I paid $399 for the clutch kit and would like $325 shipped for the clutch kit and $150 shipped for the flywheel. Will combine for a shipping discount. Will also accept trades- large case (E28 or E30) 3.64 ish w/ LSD.
Contact info:
Email- lateapex31 'at' comcast 'dot' net
AIM: lateapex31
or message me through the PM system
Comment