19lb injectors, M30 027 AFM with custom bracket

[einstein57]

I'm planning on making the switch to MS and forced induction so i'll no longer need this setup. I've had this on my car for about a year and it works great and passes smog with flying colors. Just add a cone filter and your ready to go.

Cost to me
$110 for 19lb mustang GT injectors (flow matched with new filter)
$65 027 m30 AFM
$25 on metal and bolts for bracket (plus several hours of mock up)
$10 coupler reducer and hoseclamps
-----------------------------------------------
$210 Total

Sold!!!!
Sold!!!!
Sols!!!!

[accident]

how much of a difference does this make? i may be interested.

[einstein57]

I just remembered I did not through away the filter so its included in the sale. It does not make a huge difference and is mostly noticeable at higher rpms. Also gained a couple mpgs. Willing to trade for turbo parts.

[einstein57]

Some info i found about this setup

http://www.davelength.net/car/bigsix.html

RWHP Torque
M20 AFM 138.4 137.1
M30 AFM 143.0 140.6
M30 AFM + 4bar FP 145.1 141.6

[einstein57]

bumpage

[Cha Ching]

I just remembered I did not through away the filter so its included in the sale. It does not make a huge difference and is mostly noticeable at higher rpms. Also gained a couple mpgs. Willing to trade for turbo parts.

Einstein, did you use a chip with this setup? I think the chip is where you get the most benefit out of this setup, no?

[BlUe E30]

yes the chip is the best set up with this but its not required, i did feel a difference when i switched to this set. i now have a chip and its even better. i recommend it but also helps if you have say ported intake manifold and ported throttle body. also makes its sound cooler... :)

[BlUe E30]

also einstein how do i go abouts making a bracket like that? i have mine kinda half assed and tied up to the oe bracket. your looks ALOT cleaner.

[BimmerScreamer]

pm'd very interested

[einstein57]

Cha Ching
No chip needed. Just adjust by a couple clicks on the afm. I had it smogged and the guy was amazed how clean it ran. And i quote "this car must always pass smog, huh". Not bad for adjusting it based on throttle response. LOL

Blue E30
I bought the metal stock at home depot. I made a cardboard templete first and transfered it to metal useing a jig saw. Not the prefered method but it was all i had. Then i welded everything together. Total build time from design to finish was about 4-5hrs. I was considering making them as a kit but i would have to get them laser or water cut cause it just takes to damn long.

Bimmerscreamer
PM replied.

Also on a side note. Even though these only have about 15k miles on them i'll probably ultrasonic clean them before i ship them. Gonnah get one at harbor freight this tomorrow.

[einstein57]

$175 shipped and i'll include a ractive shielded cone filter

[einstein57]

bump

[einstein57]

$160 shipped. I need this gone so i can buy more turbo parts.

[einstein57]

[einstein57]

Sold!!!!
Sold!!!!
Sold!!!!