FS: 10mm and 15mm spacers (So Cal)

[einstein57]

I recently bought these spacers for my ronals but i measured incorrectly and they won't clear my calipers. (Forgot to take in to account the corrado rotors have a thinner hat.) These are dual drilled 4x100 and 5x100 so they will fit VWs as well. They retail for $48 shipped for the 10s and $58 shipped for the 15s. $45 shipped for the 15s. I changed the internal beveled edge on one of the 10s to make up for the lip on the corrado rotors. i did a pretty decent job and does not effect mounting on standard setup.


***SOLD***

[evoDRichie]

are these hubsentric? and are there 4 spacers

[einstein57]

Yes and yes. 57.1 center bore.

[e304me]

I will take a set, when i figure out which one i need

[Kev]

wait do these fit for ronal's??? this is the combo i want but i havent lookd up any info on it cuz wasnt looking for some now that i saw these i may take them of your hands...

[einstein57]

I have not tried the rears but the fronts sat hella flush with 225/50/15's and 2.7 degrees of camber and 10mm spacers. The tire pokes a couple mm past the fender with the 15mm spacers in the front. I'll be running 12mm and 20 once these are sold.

[einstein57]

Will consider trades for eurogrils, crack free dash, or 38mm wastegate.

[balbonrsx]

i might pick up the 10mm if you're goin to the meet this friday,

[ed94r]

Oh Geez, I bought a set of 10mm spacers based on your recommendation to fit a Ronal to an RX-7 kit.

Great.

[vlad]

I'll take both for $75 shipped, PM me your paypal info
thanks

[einstein57]

Oh Geez, I bought a set of 10mm spacers based on your recommendation to fit a Ronal to an RX-7 kit.

Great.

The way I measured was by placing the spacer on the wheel, then setting the caliper and rotor on top. When you set the caliper on the hub it sinks a little. If you run the 3mm spacer behind the rotor like massive suggest it should not be a problem. You could also shave the caliper edge a little but it would be a close fit.

[Stephen]

ergh do want

[einstein57]

Just to clear up a few questions these have a 57.1 center bore and a beveled outer edge. These are not a true hub to hub extension like the ecs or h&r spacers. Here is a better picture to illustrate. Also a picture of the 10mm that i modified. Just want o be sure everyone is 100% sure of what there looking at.

[turbo325i]

Sold yet?

[einstein57]

Nope. Lots of interest, no trigger fingers.