Announcement

Collapse
No announcement yet.

e30 ready m30 swap. + misc

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    e30 ready m30 swap. + misc

    im doing a red top sr20 swap now.

    PRICE LOWERED
    1000 for everything.

    m30b34 from guten parts service

    setup to run on m1.3.
    i have the wiring done and 179dme going with it.

    new rear main seal
    new thermostat
    new cam oiling bar bolts and crush washers
    new "duck" gasket for the rear of the head
    new oilpan gasket
    new waterpump and gasket
    new intake manifold gaskets
    new oil filter and gasket
    new vc gasket
    new tb gasket(no installed yet)
    new bosch ign rotor
    new rad hoses, upper and lower e34

    b35intake mani
    b35 thermostat housing
    e34 pan/pump
    b35 exh. mani with downpipes
    e28 535i rad

    m5 clutch/pp
    535i flywheel
    535i slave cyl
    new pilot bearing
    all new transmission bolts
    new clutch slave
    akg style plate shifter setup with short shifter

    m30 g260 with small flange to use 325is DS installed
    matti anala motor mounts.
    comes with akg 75D motor mounts
    akg 75D trans mounts

    again, this is a complete motor ready for you to drop into your e30.

    1000 is what i want FIRM, thats a hit for me as i monied up for alot of new stuff.

    i never drove on the setup in the e30, i only mounted the motor and cooling system in the car.

    **update** i just put it in my car for storage reasons, but i dont think i'll have time to pursue an m30 e30 any longer because of my choice of major. the chance for my sr20 swap had come and gone and my offer had been bought out.

    motors must be at or under 150k miles.

    looking for well maintained m20b25/g260/173 dme/wiring setup plus 550 cash. must have a radiator to go with it
    Last edited by bataangpinoy; 10-29-2010, 09:54 AM.
    My feedback:
    http://www.r3vlimited.com/board/showthread.php?t=186328

    http://e30tech.com/forum/showthread.php?t=74911

    Instagram:
    @gears_n_glory

    @functionmotorsports

    #2
    wow grrrrrrrrrrreat say tony the tiger
    if you werent so far away !!!!
    G
    L
    W
    S

    Comment


      #3
      I'm going to start keeping a tally of the engine swaps you say you're doing. You've been through all the common ones now.
      Originally posted by LJ851
      I programmed my oven to turn off when my pizza was done, should i start a build thread?

      Feedback

      Comment


        #4
        i cant pass up the deal im getting on the red top with trans..
        My feedback:
        http://www.r3vlimited.com/board/showthread.php?t=186328

        http://e30tech.com/forum/showthread.php?t=74911

        Instagram:
        @gears_n_glory

        @functionmotorsports

        Comment


          #5
          Originally posted by Anguz View Post
          wow grrrrrrrrrrreat say tony the tiger
          if you werent so far away !!!!
          G
          L
          W
          S
          if u arrange the shipping i'll have no problem shipping it. but be warned, $$$
          My feedback:
          http://www.r3vlimited.com/board/showthread.php?t=186328

          http://e30tech.com/forum/showthread.php?t=74911

          Instagram:
          @gears_n_glory

          @functionmotorsports

          Comment


            #6
            I'm not sure you realize what you're getting into
            Originally posted by LJ851
            I programmed my oven to turn off when my pizza was done, should i start a build thread?

            Feedback

            Comment


              #7
              for shipping? probably not.. but frieght is my friend
              My feedback:
              http://www.r3vlimited.com/board/showthread.php?t=186328

              http://e30tech.com/forum/showthread.php?t=74911

              Instagram:
              @gears_n_glory

              @functionmotorsports

              Comment


                #8
                sigh! its ok il come across on another deal in the west coast
                BUMP

                Comment


                  #9
                  up we go guys.

                  1300 i think is a fair price, especially since i paid 800+ for all the b35 stuff including the trans and flywheel and all the m1.3 sensors, ecu etc...

                  paid a little under 4 for that motor and then another 4+ for gaskets and stuff.

                  thats 2g + right there. im trying to get rid of this asap!
                  My feedback:
                  http://www.r3vlimited.com/board/showthread.php?t=186328

                  http://e30tech.com/forum/showthread.php?t=74911

                  Instagram:
                  @gears_n_glory

                  @functionmotorsports

                  Comment


                    #10


                    My feedback:
                    http://www.r3vlimited.com/board/showthread.php?t=186328

                    http://e30tech.com/forum/showthread.php?t=74911

                    Instagram:
                    @gears_n_glory

                    @functionmotorsports

                    Comment


                      #11
                      i hope you got a magical stash of cash to fab everything for that sr swap.

                      GLWS
                      Originally posted by jasonsnoddy
                      I don't always drift, but when I do, I prefer ford fiestas

                      Comment


                        #12
                        i will be doing most of the fab.
                        My feedback:
                        http://www.r3vlimited.com/board/showthread.php?t=186328

                        http://e30tech.com/forum/showthread.php?t=74911

                        Instagram:
                        @gears_n_glory

                        @functionmotorsports

                        Comment


                          #13
                          trade me something for it.
                          sigpic
                          New website releasing soon www.gutenparts.com Guten Parts + Service | Facebook | Twitter
                          ____________________________________

                          Levent
                          %20levent@gutenparts.com

                          ____________________________________
                          Ladies:
                          1998 E36 m3/4/5 1988 325i 1989 325iT

                          Comment


                            #14
                            bump
                            My feedback:
                            http://www.r3vlimited.com/board/showthread.php?t=186328

                            http://e30tech.com/forum/showthread.php?t=74911

                            Instagram:
                            @gears_n_glory

                            @functionmotorsports

                            Comment


                              #15
                              was it sold. how many miles on the motor

                              The Build:
                              http://www.r3vlimited.com/board/showthread.php?t=191125

                              Comment

                              Working...
                              X