If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Not sure if sports, but they came off struts with Bilstein sports so assume yes. Mileage is unknown, although rust is minimal and only on the surface of some areas. Rears are very clean and shows no rust whatsoever.
The fronts are the same on all 6 cylinder cars.
They have a bit higher spring rate in the rear due to verts heavier rear end but will fit on coupes or verts.
The fronts are the same on all 6 cylinder cars.
They have a bit higher spring rate in the rear due to verts heavier rear end but will fit on coupes or verts.
The fronts are the same on all 6 cylinder cars.
They have a bit higher spring rate in the rear due to verts heavier rear end but will fit on coupes or verts.
Thing is I have a 87 vert and don't want the back end to end up sagging..lol Going to use them with billy HD's
Hey just waiting to find out if the rears will be ok for the vert. If they are without any sag, I'll be taking them. pm me your paypal please.
oh btw...what is the drop on the front and rear?
The rear springs are not the best for a convertible...the part number below is specific to the vert:
EIBACH PRO KIT LOWERING SPRINGS PART NUMBER 2010.140 FITS:
BMW 325i 05/1986 - 05/1993 2010.140 $247.99
Car Trim: Convertible 6 Cyl.
Product Specs: 1.7 in Front / 0.8 in Rear
Comment