Z3 1.9L short shift, IE bushings, aluminum carrier

[richardb]

New Z3 shift lever
New bushings, washers, clips
New nylon shift cup
New IE Derlin shift tower bushings
325is 260 aluminum shift console
325is 260 selector rod

Sold

[e30euro]

what about just the shifter? its the one piece i need bad

[richardb]

It's a nice little package

[e30euro]

i know but everything else i have even the zhp knob i got it in the mail today from blunt tech took two days i have the uuc dssr new everything really.

[tbone714]

So this is basically ready to drop in? no need to rebuild? how was the side/side up/down play when you took it out? very intrested.

[richardb]

The arms are used, the bushings, lever, washers, cup are new. This is essentially a rebuild kit ready to drop in, hasn't been used yet.

[BewWoo]

Hey is this coming off a Late or Early model? I recently did a swap from an auto to a manual on my late model but we pulled the selector rod out of an early model. As a result, R-1-3-5 are so far forward the shift hits the center console and 2-4 are in the vertical position where Neutral should be. I'm looking to swap for a late model anyway, so I'm considering the short throw.

[Evilsmith]

Hey is this coming off a Late or Early model? I recently did a swap from an auto to a manual on my late model but we pulled the selector rod out of an early model. As a result, R-1-3-5 are so far forward the shift hits the center console and 2-4 are in the vertical position where Neutral should be. I'm looking to swap for a late model anyway, so I'm considering the short throw.

Had the same problem, try turning the shifter 180 degrees, your bend is going in the wrong direction.

[richardb]

Mustache cash stash

[richardb]

Top

[Frog]

nice

[richardb]

Perfect for someone doing a 5 speed swap or 24v swap and needs linkage

[richardb]

Up

[richardb]

Up

[richardb]

Top