Help me make the picnic, parts FS. Vert maplight mirror, markd etc..

[Justin B]

Trying to get to the picnic, and I need to pay off the rest of my project's parts before then. Ill post more later, but to start out...

I ran this markd chip on my m20 for a couple of years and loved it. I have since installed an m52, so I don't need this anymore.
It's a 380 ecu with a 173 chip inside. Specs are for 91 octane, 17 to 19 lb injectors, and a 7k rpm limit.
$175 shipped cont. US


Rear view maplight modified for use in convertibles. Crimp on your own connectors, mine came apart when I was trying to separate the spades. Tap in on the wires for the stock maplight. I made a little harness to run my v1, the stock maplight, and the mirror without splicing, but that's long gone. Idea though.
$65 shipped cont. US

[Justin B]

Bump, lowered $

[deutschman]

bump for justin. good guy.

[Justin B]

Bump. This maplight is a HUGE improvement over the oe center mount one in verts.

[Ceeker]

Bump. This maplight is a HUGE improvement over the oe center mount one in verts.

I was thinking the same thing; but my only concern was how to hide the wiring. I took one regular maplight and tapped into the overhead display panel and works fine rather then running the wires down the a pillar.

looks nice GLWS.

[Justin B]

Thanks. The wires are hardly visible, and could be covered in a small section of black shrink tube to blend it with the window mount. For the whole half inch or so that is visible, the wires route up to the check panel/original vert maplight wiring that already has 12v there to tap into. I tucked the wire between the windshield and the front edge of the top panel.

Bump.