If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Update on camber plate!
I have decided to manifacture spring plates with bearings too. So this is the scetch of all parts assebled. Only colloring left.
Short shifter with reverse protection. Widely used and loved by racers in EU.
*Reverse or 5th(good for drifters) gear protection
*Adjustable knob travel
*Ertalon shift knob (doesn't get cold)
*Polished aluminium
*Bearings all around moving parts(NOT SLEEVES)
Will have 2 of these by monday, if you are interested don't waste time ;)
*Huge "Fluro" bearings, can hold up to 160kN loads.(id=22, od=42, h=20)
*Available 42 mm total travel (24 to negative camber!!, 18 to positive)
*10.9 class bolts
Short shifter 352$:
*All moving parts use bearings
*Ertalon shift knob
*Reverse or fifth gear protection(adjustable)
*Adjustable shortness of gears
Comment