I'm selling my old block, but here's the deal: It comes with JE 10.0:1 compresion 1mm overbore pistons, 325e connecting rods, 524td crank, and an oil pump. No oil pan, no head. The pistons and rods are actually good and don't show any signs of damage, but it needs a new crank because the hole at the end for the key is so large that it's not much use anymore. Dunno if it's machinable but the easiest and cheapest replacement is an eta crank.
The pistons alone were $1,000 new, the machine work for the block was a few hundred, and the bearings/freeze plugs/etc were all replaced. The block probably weighs in the 200 lb range so no shipping on that. If there are no takers on the block, I'm willing to sell the pistons and rods seperately. Asking $600 for the pistons and rods alone, $800 for everything.
The pistons alone were $1,000 new, the machine work for the block was a few hundred, and the bearings/freeze plugs/etc were all replaced. The block probably weighs in the 200 lb range so no shipping on that. If there are no takers on the block, I'm willing to sell the pistons and rods seperately. Asking $600 for the pistons and rods alone, $800 for everything.
Comment