FS High perfromance M20 stroker motor:
The absolute best parts avaliable were used including:
- Professionally built by Apex Engineering
- Fresh with zero run time
- Forged BMW diesel 2.8 litre crank lightened and knife-edged and micro polished
- Forged JE 10.5:1 compression pistons with total seal gapless rings
- Forged chromoly Pauter rods, longer custom length, ultra light and strong
- Block was polished and de-burred
- Cylinder head has new valves, valve guides, performance valve springs, titanium retainers, chromoly keepers, new rocker shafts and rocker arms.
- High performance valve job including CNC de-shrouding of valve pockets and port work that was then hand finished and blended
- Schrick 288 camshaft
- Intake manifold match ported to head
- Engine was comlpletely dynamically balanced inlcluding new aluminum flywheel and sport clutch assembly, new harmonic balancer and pulley
- Other new parts include timing belt, tensioner, water pump, Race Wear head stud kit, hardware and gaskets
- Motor also includes custom fabricated race oil pan complete with extended sump for additional oil capacity, hand crafted windage tray and oil control panels
- Oil filter housing tapped for AN fittings
- Also includes intake manifold port matched to cylinder head
- Engine power output estimated at 280bhp @ 7200rpm with correct engine management and exhaust
- Engine is completely assembled and ready for install
- Offered at $7,500.00 OBO
PM if interested.
Thanks,
Trent
Comment