FS m20 325ix Motor Complete $100

[danse30m3]

Pulled from a 1988 325ix with ~200k miles.
Car started and ran fine with no issues.
was rusted and parted out.
Complete from Oil pan to throttle body, intake and exhaust manifolds
No accessories, ecu, diff, flywheel or clutch.
Cleaned and on engine stand.
I was going to disassemble and sell parts.
Now I need the space and it gone.
pick up only, I have a hoist and can load into pick up.
email only dan@fpcsalemnh.com
First $100.00 takes it away.

[BlueIX]

Bump for a great deal

[F34R]

This is the SETA engine everyone, bump for 2.8 stroker people!

[BlueIX]

This is the SETA engine everyone, bump for 2.8 stroker people!

Pretty sure the ix's did not come as an SETA, just a standard 2.5i m20.

[F34R]

Pretty sure the ix's did not come as an SETA, just a standard 2.5i m20.

You are correct :finger:

[gotaloveRWD]

would all i have to change is the oil pan to make this engine work on my 88 325is?

[BlueIX]

No, there is a lot more involved. The ix has different oil pump location and I believe a hole or holes have to be drilled to make it work. The head is the same though.

[dannyyisntt]

If you were in Michigan, I'd buy this. GLWS!