M50 non-vanos

[sidewaysdave]

I have an m50 non-vanos for sale. has everthing, but wireharness, intake manifold, maf, and oil cap.

I picked this motor up from Ryan Strenzack(sp?) here in winston. Millage is unknown, but did run when pulled.

Asking $300 firm. UPDATED: pics below.

Buyer is responsible for pick up and delivery.

[brutus87]

good price.

[ecc3189]

PM sent

[GunMetalGrey]

^ your sig :O

[sidewaysdave]

Bump, still for sale.

[sidewaysdave]

Bump! No one wants a non vanos for a turbo project or cheap motor to drop in? I'll take 300 if it gets this thing out of my garage.

[sidewaysdave]

bump

[e30rapidic]

I have an extra NV harness laying around if you/buyer need.

[lookitsranday]

Willing to ship to 90804?

[n3nyongmini]

this needs to be closer to Houston....

[sidewaysdave]

Willing to ship if you are willing to pay for shipping, shipping could cost just as much as the motor depending on where 90804 is located though. anyone know the weight of this motor drained off the top of their head. and sorry for the delay on posting back. im on the forums every couple of days so if you send me a private message im more likely to notice your question and respond back more promptly.

[sidewaysdave]

bump, bump, bump...

[sidewaysdave]

bump, I have a parts car diamondshwarts 318is(still runs, but blown headgasket), mint back door panels(no seats), mint dash in car, give the paint and car as a whole a 6 out of 10. it has been repainted by PO , sun faded m50 intake manifold, wireing harness from an e36 motor(not the one from the m50 think it may be s50, friend left it with me so im not sure, but its a wireing harness for a swap none the less. willing to sale all these parts plus motor as package deal for 1100.

car also has smoked euro elipsoids on it.

car has clean tittle and ready to be signed over to new owner

also have an s52 block and crank, the motor was hydrolcoked by a guy with a long air intake who hit a puddle and took a chunk out of the bottom of one of the cylinder walls, but according to machinest it not terminal because piston wouldnt have traveled that low unless it was hydrolocked and wont do it again unless under the same extream conditions. crank is in good condition with no damage to it from the motor hydrolocking ill take 450 for the block and crank, wont split these two items so please dont ask me to.

If interested in any of the car items please let me know via private message, thanks.

[sidewaysdave]

bump

[Alexbailey228]

Do u still have the engine I live close by would need a harness as well