Whole Car Part Out! And Some extras.

[evil_twin]

Parting out a whole car. Let me know what you need. Prices are going to be relatively cheap. 4 door, full interior.

No motor, trans, clutch pedal assembly, suspension, or front control arms anymore.

Shipping will be from Centreville, VA 20120

So I got a few things for sale that I'm just trying to move out of my garage. The 24v stuff came off a 1996 3.28 with 77k.

All prices are without shipping. Pick up is preferred though. Shipping would be FROM Centreville, VA 20120


M52 Coils. Asking $100


M50/M52 Oil filter housings. Asking $60ea.


E39 528 Oil Pan. Asking $70


E36 M52 Oil Pan with dip stick. Asking $80


M52 Exhaust Manifolds. Asking $50


Borbet Wheel Studs. For stock fitment. Asking 5 + shipping


E30 Tail lights with backings. Asking $50






Tinted E30 Tail lights. Asking $60



Left rear control arm/hub assembly. Asking $50


I have a complete 4door late model e30 that I am parting out. The front end has been wrecked. The engine, transmission, drive shaft and clutch pedal set are spoken for. The interior is tan, and the drivers seat is torn pretty bad. Everything else in the interior is in good condition. The vehicle is a 1990. Exterior is PINK. I'll get some pictures up soon. Let me know what you are interested in. Trying to move this car.

Interior of the 4door.

Quoted from a local thread.

I'll put more pictures up as I go.

[Madinthe717]

gauge cluster shipped to 17036 hummelstown pa

[Jose_perez0711]

would u ship a driver side fender? to 78758 austin tx

[richardb]

Nice prices on the obd2 manifolds and tails!

[b15u]

Hey do you have the hood release cable and seat belt receiver?

[evil_twin]

gauge cluster shipped to 17036 hummelstown pa

No gauge cluster, sorry.

would u ship a driver side fender? to 78758 austin tx

No fenders, sorry.

Nice prices on the obd2 manifolds and tails!

Thank you.







All PMs replied.

[evil_twin]

Bump!

[bimmershark]

i need a fuel pump assembly with the pump connector and a foot of wiring if ya have it ..no pump or sending unit needed

[evil_twin]

PMs and emails replied.

[OnMy2ndE30]

front door pulls and pockets shipped to 78253????????

[evil_twin]

PMs replied via email.

[irish44j]

did you used to have the 3rd gen Maxima? If so, I know you from back in the maxima.org days (if not, nevermind).

Either way, might want to come out that way and take a look at what you have for interior stuff, etc....

[evil_twin]

haha Jason? I seen you a couple of times. I thought you had a subaru?

[ianxflo]

Euro Plate filler still available?

[irish44j]

haha Jason? I seen you a couple of times. I thought you had a subaru?

close....Josh ;)

Jason (cutler) is still around in Chantilly, but has a Legacy GT wagon and a Z06
Jason (soonerfan) is in oklahoma and has a Volvo or something, llol

I do have a subie...09 WRX. Just picked up this 318 to setup for Rallycross (so as not to trash my still-being-paid-for daily driver subie, lol).

been what....6 or 7 years now, lol..