First I have an IE windage tray for the M20. I received this via UPS with some slight twists to it. Ireland sent me another one so now I am going to sell this one. It is definitely useable and I would seal just fine with the pair of suggested gaskets(gaskets not included) Shipping is a tad pricey at $15-20. List price from Ireland is $48 and I paid $17 in shipping from them. Asking $50 shipped obo.
Next I have a new unused drive shaft center support bearing. PN 26-12-1-226-723. Should be for late model drive shafts but please do the research to be sure that will fit your drive shaft. Lists for $20+ shipping, I am looking to get Sold.
Also I am disassembling an 87i motor. I will post up specifics of parts that are pulled and ready to ship but feel free to ask about any parts from it. The only thing sold thus far is the starter.
Oil Pan - Clean, some scrapes on the leading edge but no cracks or holes. $65 shipped
Alternator- Good used alternator. No issues prior to removing engine. $45 shipped
Power Steering pump with reservoir and lines Sold
Power Steering Pump Sold
Single mass flywheel with used clutch, pressure plate and throwout bearing. Pressure plate
thickness is around 9.5mm. Sold
885 Head - Cleaned, pressure tested and decked with little use after work was done. Looking to get $225 + shipping
Next I have a new unused drive shaft center support bearing. PN 26-12-1-226-723. Should be for late model drive shafts but please do the research to be sure that will fit your drive shaft. Lists for $20+ shipping, I am looking to get Sold.
Also I am disassembling an 87i motor. I will post up specifics of parts that are pulled and ready to ship but feel free to ask about any parts from it. The only thing sold thus far is the starter.
Oil Pan - Clean, some scrapes on the leading edge but no cracks or holes. $65 shipped
Alternator- Good used alternator. No issues prior to removing engine. $45 shipped
Power Steering pump with reservoir and lines Sold
Power Steering Pump Sold
Single mass flywheel with used clutch, pressure plate and throwout bearing. Pressure plate
thickness is around 9.5mm. Sold
885 Head - Cleaned, pressure tested and decked with little use after work was done. Looking to get $225 + shipping
Comment