$2000 obo + FREE SHIPPING
I have for sale is my built m50 bottom end. Reason for selling is that i have another build im going to be starting soon and i need money to fund it. All of the machine work has been done at C&P Machine in fort wayne, i still have receipt for the machine work. Block was bored .020" bored, line honed, resurfaced and o-ringed. crank was magged, oil holes chamfered, then micro polished. I had rods recondition from peerless out at E30 motorwerks. Pistons are 9:1 wiseco, Arp head studs, Main studs, and rod bolts. clevite rod bearings, and vac motorsports main bearings. oil pump nut is saftey wired. This is just the bottom end that is forsale, Head, valve cover, alternator, flywheel, starter is not included there are less than 3000 miles and 3 events on this engine.
*****EDIT****
Rods after reconditioning.the were shot peened, then had the caps cut and big end resized, and had new bushings installed on small end and machined to wristpin size,
ARP hardware that i used.
Not a very good picture, but these are the wiseco pistons.
video of the engine in action. https://vimeo.com/48761300
i had a safe tune on it making 320whp and 306 tq engine was very well maintained and oil change after every event. would like $2200
i have more pictures and a full build thread on here and e30tech.
also currently located in detroit mi
I have for sale is my built m50 bottom end. Reason for selling is that i have another build im going to be starting soon and i need money to fund it. All of the machine work has been done at C&P Machine in fort wayne, i still have receipt for the machine work. Block was bored .020" bored, line honed, resurfaced and o-ringed. crank was magged, oil holes chamfered, then micro polished. I had rods recondition from peerless out at E30 motorwerks. Pistons are 9:1 wiseco, Arp head studs, Main studs, and rod bolts. clevite rod bearings, and vac motorsports main bearings. oil pump nut is saftey wired. This is just the bottom end that is forsale, Head, valve cover, alternator, flywheel, starter is not included there are less than 3000 miles and 3 events on this engine.
*****EDIT****
Rods after reconditioning.the were shot peened, then had the caps cut and big end resized, and had new bushings installed on small end and machined to wristpin size,
ARP hardware that i used.
Not a very good picture, but these are the wiseco pistons.
video of the engine in action. https://vimeo.com/48761300
i had a safe tune on it making 320whp and 306 tq engine was very well maintained and oil change after every event. would like $2200
i have more pictures and a full build thread on here and e30tech.
also currently located in detroit mi
Comment