FS: CHEAP M50 Non-Vanos Parts-- Short blocks, cylinder heads...

[Brew]

-2 M50 Non-vanos short blocks (block, pistons, rods, crank) --$300 for both

-Stock non-vanos cylinder head ~140k miles -- $150 SALE PENDING

-Non-vanos cylinder head w/ custom s50-spec cams, resurfaced, ready to be assembled and installed -- $600

-Non-vanos engine harness from an e34 -- $100SOLD

-Non-vanos DME w/ Dinan chip - $150 shippedSOLD

-Non-vanos, hot wire MAF -- $80 shipped


Pick-up only for the short blocks and cylinder heads.

[e30Matt]

What kind of condition are the blocks in?

[Brew]

One of them was in my old e30m50, has about 130k according to the seller. I'll have to get back to you when I get the motor disassembled, but I don't have the time to measure clearance and whatnot. The other shortblock is disassembled, and looks to be in good condition. To be honest, I can't guarantee that either of them are in perfect condition, which is why I'm letting them go for cheap, and selling them together. I also can't deal with shipping them at this point, sorry.

I'm putting an ad on bimmerforums also, as these parts appeal a bit more to someone who already has an M50.

[Low Level E30]

Non-vanos cylinder head w/ custom s50-spec cams, resurfaced, ready to be assembled and installed -- $600

Hey Brew - Who ground these S50-spec cams? Any further details on them?

Thanks,

[Brew]

Hey Brew - Who ground these S50-spec cams? Any further details on them?

Thanks,

I bought them, along with the cylinder head, from "cheades". I believe he is a member of this forum, but we went through bimmerforums. I can ask him who did the machining if you'd like.

[Low Level E30]

I bought them, along with the cylinder head, from "cheades". I believe he is a member of this forum, but we went through bimmerforums. I can ask him who did the machining if you'd like.

Absolutely, yes please. Wondering also if they're re-ground, or ground from new.

[Addissimo]

Hey-

Brew said he got a cam from you for the non-vanos motor. I'm wondering if you have another available? If not, can you send me in the direction of where to get one?

Thanks
-Addis

I sold both of my sets I had, but talk to Delta Camshafts in Tacoma. They were good to deal with and very quick on turnaround.

[Brew]

Thanks Addis. According to cheades, they are re-grinds.

[Brew]

buymyshit

[e30Matt]

What about the NV head?

[Brew]

What about the NV head?

The one I was planning on using is in great condition. Its still wrapped up in plastic from when I had it resurfaced a few weeks ago. Completely disassembled, so whoever buys it will need to put in valve seals(which come with most head gasket kits). Cams are unused, S50-spec regrinds, as previously mentioned. I was planning on replacing all the hardware on it, so all of the studs are removed and will need to be replaced.
I paid $500 for the complete head, and $175 at the machine shop (checking for cracks, resurfacing).

[grapedrink]

How much for the cams alone?

[jon volk]

Any chance of delivery to Milford, CT on the short blocks and stock head?

[Brew]

How much for the cams alone?

I'd rather not sell them separately- I think I'd have trouble selling a cylinder head without cams.

[Brew]

Any chance of delivery to Milford, CT on the short blocks and stock head?

I really don't have any time to deliver them, sorry.