I just made two of these, but i am keeping obe for my swap
It is an early model wide/offset selector joint that i removed the craptastic plastic bushing and pressed in a bearing grade bronze bushing.
The selector joint was only used for about a month after i bought it brand new and when i pulled my transmission to replace the seals, i noticed that the plastic had become very sloppy. So I drilled it out, and pressed in the bronze, and drilled it to 10mm. This bronze should last forever and will tighten up your shifter play.
So this is practically new. The metal housing was used for about a month, but it has not been used since the bronze was pressed in.
As i said, it is for the early models, but i could machine it to the width of the newer skinny one if needed.
These are about 35 new, so im thinking 45 shipped, also open to partial or fupl trade for near or interesting things.
New Price---40 Shipped
It is an early model wide/offset selector joint that i removed the craptastic plastic bushing and pressed in a bearing grade bronze bushing.
The selector joint was only used for about a month after i bought it brand new and when i pulled my transmission to replace the seals, i noticed that the plastic had become very sloppy. So I drilled it out, and pressed in the bronze, and drilled it to 10mm. This bronze should last forever and will tighten up your shifter play.
So this is practically new. The metal housing was used for about a month, but it has not been used since the bronze was pressed in.
As i said, it is for the early models, but i could machine it to the width of the newer skinny one if needed.
These are about 35 new, so im thinking 45 shipped, also open to partial or fupl trade for near or interesting things.
New Price---40 Shipped
Comment