NJ FS M20 block with pistons, auto driveshaft, auto flywheel and auto trans bracket

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Ricky_J
    Wrencher
    • Feb 2012
    • 222

    #1

    NJ FS M20 block with pistons, auto driveshaft, auto flywheel and auto trans bracket

    Hello,

    I have a M20 block with pistons and rods. The previous owner spone the rod bearings and damaged the crank. The pistons are in ok shape and the block is good.
    I also have a drive shaft for an automatic 325I. (Need center bearing)
    I have a automatic flywheel with flex plate.
    And an automatic trans bracket with trans mounts.

    I want:

    Block with pistons 50.00

    Flywheel with flex plate 10.00

    Trans bracket with trans mounts 15.00

    Driveshaft 40.00

    Now to be clear. If you want to know if this engine can flight a plane up to 50mls/h on a rainy day with a humidity of 50% well I'm affraid I don't know the answer.
    If you have more questions than OJ jury well you should read his book because he explained how he would done it if he did it.
    If you just finished watching Wall Street and want to negotiate everything you're gone buy today well you should not contact me and go be an a$$hole somewhere else.
    I don't think my prices are that steep.
    If you want to argue pennies with me, you should just grab your lunch money and go get yourself an ice cream because it will make yourself feel much better.

    I hope I got you guys laughing a little. If I didn't and offended you well too bad.
    Here are some pictures.
    And yes I know they suck but if you got something against them just remember that I don't really care. Get off your couch and come look at them yourself.

    Thank you































    Last edited by Ricky_J; 06-05-2013, 10:26 AM.
    sigpic
  • Ricky_J
    Wrencher
    • Feb 2012
    • 222

    #2
    bump
    sigpic

    Comment

    • Ricky_J
      Wrencher
      • Feb 2012
      • 222

      #3
      Bump
      sigpic

      Comment

      • Ricky_J
        Wrencher
        • Feb 2012
        • 222

        #4
        Bump
        sigpic

        Comment

        • Ricky_J
          Wrencher
          • Feb 2012
          • 222

          #5
          Bump
          sigpic

          Comment

          • Ricky_J
            Wrencher
            • Feb 2012
            • 222

            #6
            Bump
            sigpic

            Comment

            Working...