FS: Turbonetics Ceramic Ball-Bearing Turbo

[///schwartzman]

I'm doing a slight upgrade so I don't need this turbo anymore... It's a Hybrid TO4E /T3 ceramic ball-bearing turbo in 50 trim w/F1 exhaust wheel, no play, wheel spins freely, tested at 420whp on 2.5L 4 cylinder S14 motor... Capable of @480. Used for less than 100 miles, of road tuning. Still have the box from the refresh from Turbonetics. The exhaust housing is a ported .82 a/r 2000 deg. Ti ceramic coated inside & out to keep the heat where it should be.

$700+s/h or interesting trades...







Embee Ti Ceramic coated exh. housing

[///schwartzman]

You can barely see the a/r housing is a .82 since it was ported quite well.



5-bolt


Things I might consider as full/partial trade:

S14 cambox or head w/cambox

Any BBK 300mm+

3.46S Diff.

a set of BBS wheels RC, RK or RS's in 17" x 8.5"

new 97+ M3 control arms

GC coilover setup

StarTac rear lights

shim under bucket setup

Stock steel hood (sold mine prematurely)



Man it seems like this could be a never ending project.