If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a BMP gauge pod which fits in the center vent hole in the dash of an e30. I was using this in my car but recently removed it. It does have a few scratches on it. Holds 3 standard 2 1/6 guages. They don't make these anymore. $100 shipped
86 325es, built 2.8L non vanos m50, borg warner s366, megasquirt 2, ford 9 inch rear end with 4 link, 325 drag radials, T56 magnum trans, mantic twin disc clutch, zip ties, tape spray paint
