So, I've been wanting a new taller shifter with some decent weight, and none of the ones I've seen really fit the bill for me. So I designed my own, and am looking to have a run produced to bring the cost down a bit. The shifter will be CNC machined from billet aluminum, with a raw machined finish (might be able to polish for a fee). Shifter will $80 shipped to the ConUS if I can get 10 people on board.
specs:
weight: 1.3 lbs.
height: 6.1 in.
material: billet aluminum
Install: Four 1/4-20 set screws (included)
Here is a rendering of the design:
If you are seriously interested post up so I can see where it stands. This won't be a regular production item, I'm just doing one run to get the cost down, it just happens that offering these up to the community makes it cheaper for everyone.
specs:
weight: 1.3 lbs.
height: 6.1 in.
material: billet aluminum
Install: Four 1/4-20 set screws (included)
Here is a rendering of the design:
If you are seriously interested post up so I can see where it stands. This won't be a regular production item, I'm just doing one run to get the cost down, it just happens that offering these up to the community makes it cheaper for everyone.
