SOLD
THIS IS FOR SALE - PULLING MOTOR SOON
I am collecting parts for an S52 swap, so I am listing this to give time for people to come see it and drive the car if interested.
Motor has 220k on it, from a 1989 325i. Everything was maintained very well before I bought the car 6 months ago. There are no leaks, much of it has been degreased and cleaned thoroughly. Since then I have done the following:
Transmission not for sale - NLA
New timing belt
New tensioner
All new accessory belts
New 80c whaler thermostat
New Water pump
New eccentrics, bolts, nuts
New Spark plugs
New bosch wires
New bosch ignition cap and rotor
New bosch coil pack
Chanaged the oil 3 times with valvoline vr1 20-50 (will include a case of 6 if I don't change oil again before selling)
(will also include 4 mahle filters)
Valves adjusted
Valve cover gasket
New oil sprayer bar
New engine mounts
Painted the VC black with ceramic paint (was also planning to do the IM but not sure I will have time to finish that)
Pull out includes clutch, flywheel, PS pump, AC compressor, AC lines, AC condensor, wiring harness, DME, coolant hoses and lines, radiator, all of the intake tract fuel rail etc everything attached to the motor goes.
Asking $450
THIS IS FOR SALE - PULLING MOTOR SOON
I am collecting parts for an S52 swap, so I am listing this to give time for people to come see it and drive the car if interested.
Motor has 220k on it, from a 1989 325i. Everything was maintained very well before I bought the car 6 months ago. There are no leaks, much of it has been degreased and cleaned thoroughly. Since then I have done the following:
Transmission not for sale - NLA
New timing belt
New tensioner
All new accessory belts
New 80c whaler thermostat
New Water pump
New eccentrics, bolts, nuts
New Spark plugs
New bosch wires
New bosch ignition cap and rotor
New bosch coil pack
Chanaged the oil 3 times with valvoline vr1 20-50 (will include a case of 6 if I don't change oil again before selling)
(will also include 4 mahle filters)
Valves adjusted
Valve cover gasket
New oil sprayer bar
New engine mounts
Painted the VC black with ceramic paint (was also planning to do the IM but not sure I will have time to finish that)
Pull out includes clutch, flywheel, PS pump, AC compressor, AC lines, AC condensor, wiring harness, DME, coolant hoses and lines, radiator, all of the intake tract fuel rail etc everything attached to the motor goes.
Asking $450
Comment