F.S. 24v swap header supersprint rep v band

[chrisbmx68]

Sold

[R1dd1ck913]

Is this something that you are willing to ship?

[chrisbmx68]

yeah it should be shippable its not too gigantic. Will probably be around 35 to send ups ground.

[chrisbmx68]

also to clarify the merge collector at the end is mild steel hence the rust at the weld areas the header itself and the vband are stainless as is the chunk of my exhaust ill be throwing in.

[yugonyc]

how was the clearance relative to the sway bar, control arm, and firewall?

[chrisbmx68]

I'm running tree house cabs so I have tons of room there I think they would clear stockers fine. I dented one of the collectors slightly for sway bar clearance and I dented the subfame in a small spot for clearance. They clear everything else without mods. I will take a pic of the subframe where I dented it. This was using round m5 motor mounts which I can throw in with sale.

[f4tj0n]

Can you install and remove these without much hassle?

[chrisbmx68]

they can be removed and installed with motor in the car, but the ps side motor mount needs to be removed and engine supported with a jack so you can slide them in. then the headers and motor mount can be attached. Its a royal pain removing and tightening some of the rear most lower nuts.

[carbeater]

^^^ what headers are't a pain in the ass to tighten and loosen the lower nuts

[NightOwl]

Pm me your PayPal I'll take it.

[Dex954]

I'm local let me know if this ^ guy doesn't take it.

Sent from my Xoom Wifi using Tapatalk

[mpowerful]

I have same headers and mine clear the stock cabs fine

[E30darkknight]

I PM'd you. What's up


Sent from my iPhone using Tapatalk

[chrisbmx68]

Sold