eta driveshaft

[Jparkr]

Very lightly used. from a 325e that was wreaked about 1000 miles after it was installed. U-joints are great and smooth, its balanced and ready to install. Buyer will still need the bolts and nuts with the exception of the rear bolts that attach to the diff.
the Sizes for the inputes are:

Shaft to final drive(diff) - 17mm locking nuts (bolts included)
Shaft to Transmission - 17mm Bolts and 17mm self locking nuts

Bentleys manual says there are three types of bolts that attach to transmission threw the guibo:

8.8 - the biggest and are 19mm

10.2 - The ones you will need for this, 17mm (you will also need a 10.2 guido)

12 - The smallest i would imagine. however i have not seen these

Im asking $400 +shipping

Pics on request*

[Jand3rson]

So was this a new driveshaft?

[Jparkr]

yes it was installed new, removed aprox 1,000 miles later due to a wreak. then i got it from the guy who bought the wreaked car as a parts car but it was a 10.2 and i needed an 8.8 so im selling it.

[James Crivellone]

yes it was installed new, removed aprox 1,000 miles later due to a wreak. then i got it from the guy who bought the wreaked car as a parts car but it was a 10.2 and i needed an 8.8 so im selling it.

You can swap the output flange on the transmission yah know...

[Jparkr]

yeah but we just got an 8.8 so now i dont need it. i wish i had know that then though... damn. lol

[Jparkr]

200+shipping???
some one must need it and i dont want it taking up space in my garage.

[netcsk]

What are the year ranges? Otherwise, what is the year/production date on the car this fit on (or the prod. date it didn't fit on -- whatever)? I could use one, but it would have to be made for a pre 5/86 (also using a single mass flywheel).