I have a late model front valance and bumper set. No trim, turn signals, lip, clips.
They came with my car and during the repaint i discovered the valance had been dented and there was a lot body filler on the section below the passenger headlight. The rest of it is pretty damn straight. Just due to time constraints i got a new valance and bumper instead. This is a good opportunity to save money if you want to take the time to bang that section straight and respray.
The bumper has a crack in the same area. Its a very straight forward repair. Clean break, no sections missing. The bumper has many layers of paint and i tried to strip the paint, but its just too cold here for my bumper paint stripper to work well. 2 cans of SEM XXX bumper stripper and this should be good to go to prime and spray
I'll get a pic of the bumper later tonight. Here is the valance. I started to wirewheel the layer of stone guard on it.
Price is $300 firm for both bumper and valance. Only trade i'm looking for would be good quality tools or a working 3.73 LSD.
as you can tell its not that bad. i'm just putting a lot of work into the body and i wanted it as straight as possible so i wasn't taking any chances.
They came with my car and during the repaint i discovered the valance had been dented and there was a lot body filler on the section below the passenger headlight. The rest of it is pretty damn straight. Just due to time constraints i got a new valance and bumper instead. This is a good opportunity to save money if you want to take the time to bang that section straight and respray.
The bumper has a crack in the same area. Its a very straight forward repair. Clean break, no sections missing. The bumper has many layers of paint and i tried to strip the paint, but its just too cold here for my bumper paint stripper to work well. 2 cans of SEM XXX bumper stripper and this should be good to go to prime and spray
I'll get a pic of the bumper later tonight. Here is the valance. I started to wirewheel the layer of stone guard on it.
Price is $300 firm for both bumper and valance. Only trade i'm looking for would be good quality tools or a working 3.73 LSD.
as you can tell its not that bad. i'm just putting a lot of work into the body and i wanted it as straight as possible so i wasn't taking any chances.
Comment