m20 single mass flywheel early model - No Longer Available

[5Toes]

m20 single mass flywheel early model

early model flywheel for etas that use the bell housing mounted crank and reference sensors. works on late model too.

ready to be lightened up! comes with good condition sachs pressure plate and flywheel. pilot bearing was junk.

List Date: 10/18/2016

For more info, click here to view the original listing: m20 single mass flywheel early model
--------------------------------------
This item is no longer available.


--------------------------------------

[5Toes]

come on someone needs this for their swap! I have a driveshaft too and the clutch hardline. LETS MAKE A DEAL

$110 shipped and this puppy is yours. Ill throw it up on ebay and get alot more than that if nobody bites.

[ElJimo]

oh....I...I think I might need this? Doing a manual swap on an 88 325. new trans has the two sensors on the transmission, old auto trans doesn't. But if my stock engine has the sensor on the front, I can just not plug in the ones on the trans and i'll be good? :/

[5Toes]

^ the transmission you have is an early model and your 88 325 is a super eta that uses motronic 1.1 with the front pulley mounted crank sensor. all e30 getrag 260 5 speeds are interchangeable, only differences being the early model style shifter carrier plate.

If you dont have the shifter plate you need I have one I can throw in for a few extra bucks. You can use the early model shift carrier and just cut the wires off those sensors mounted on the bellhousing (to effectively seal the trans up/use them as delete plugs).

All m20 single mass flywheels are interchangeable as well.

[avt007]

Do you have a picture of the other side? Also, can you tell me the weight of the flywheel by itself? And the individual weights of the pressure plate and friction plate?

Thanks
Rob