Ryan's Garage Sale

[///WeissM]

- Lacarra Steering wheel with hub for E30, 14" dia. SOLD
- Oil Cap, SOLD
- Check Panel, SOLD
- 17mm Allen for tranny oil change, $12 shipped.
- Split Second PCS1-003, never been installed. $150 shipped.
- Odometer Trim Ring, $12 shipped.
- Tail Lights, $60 shipped.
- Clifford Ace 7500 Alarm, completed with sensors, remotes, SOLD.
- ColeHaan Shoe, 9.5, new. $45 shipped
- UUC Knob, SOLD
- Schroth Blue 4-point harness. SOLD.
- E30 Radio, All sold
Paypal verified member.
Ryan

[doucy2]

trades for that wheel?

[///WeissM]

Sorry, no trade (too many things in the garage) :-)

[fretburnr]

what condition and model is the UUC knob? if in average or better shape i'll take it. paypal ready.

[///WeissM]

It is in good shape. Paypal account :ryan.t.mac AT gmail DOT com
Ryan

[fretburnr]

paypal sent :) do you know which model it is?

[///WeissM]

Yes, UUC knob, sold. Thanks.
Ryan

[///WeissM]

To the top. Make offer.
Ryan

[NC325iC]

what does the split second deal do?

[///WeissM]

Quote from Split Second website:


PSC1-003 Programmable Signal Calibrator

Description:

The PSC1-003 Programmable Signal Calibrator provides precise calibration of fuel by adjusting fuel control signals. It can be used with naturally aspirated or forced induction engines. It is intended primarily for flow based systems and is generally used to adjust fuel by calibrating the mass air flow (MAF) signal.

Through a serial interface, the PSC1-003 can be programmed by a laptop computer running the Split Second R4 software. The software provides three dimensional mapping of the MAF signal. The MAF value output is determined by the active cell value. The active cell is determined by MAF sensor output voltage and RPM.

The PSC1-003 can be configured for a second mode of operation whereby the cell value is used to modify the MAF signal signal. For example, the MAF sensor signal could be modified up or down according to the table values. Other versions of the PSC1 are available that can do mapping where the primary axis is pressure. The PSC1-001 can be used to control manifold absolute pressure (MAP) based systems and has an internal 2.5 bar MAP sensor.

The calibration of the PSC1 is done through a serial interface, which is active while in operation. The R4 software runs on Windows 95/98/NT/2000. The software provides real time display of RPM, manifold pressure, and cell value. The R4 software is the same software that is used to program the AIC1. A variety of editing tools ease the task of setting up an initial map and quickly fine tuning for optimum performance.

[///WeissM]

Add more parts:
- E30 M3 Mirrors, SOLD
- Kick Panels, SOLD

[cactusjacks1]

I'll take the mirrors !! confirm availabilty by pm & I'll send pay pal.
Jack

[///WeissM]

Schroth harness sold.
Ryan

[Jand3rson]

Do you have any better pics of the oil cap? Are the M stripes colored? What's the finish like?

[///WeissM]

The M stripe is colored. The finish is smooth anodized.