Complete m20b25 with 5 speed box

[So Live]

Hey everybody,
I have a complete m20. wiring harness, oil cooler, a/c, all accesores, starter, afm, airbox. all of it.

168k miles on everything. New water pump, thermostat, timing belt b/s, dizzy cap and rotor within 10 k miles. Two new valves.

The gearbox is perfect. shifts smooth and never pops out or does anything funny.

Its out of the car. Come check it out, do a compression test pull the plugs. What ever you want to do.

$650obo. Pick up only.

Thanks alot

[So Live]

Bumpin it up. Im willing to seperate it all too.

[Scott72]

pm sent

[ZM Blue Devil]

Pm sent regarding transmission end

[Mike325]

How much for everything minus the tranny and clutch/flywheel?

[So Live]

Hey guys,
I have a few people interested in the whole thing so ill let you know. Id rather sell it together than in peices. Oh and im keeping the ac stuff. you can have the compressor ill have no use for it. Im not sure if it works i think it needed a recharge but i never had the a/c running.

quick motor pic:


You can have the radaitor hoses, all the intake stuff (even my 'swiss cheese' airbox with fairly new k&n)

I also have the drive shaft! $50 for that.

Im trying my best to get some of the money im spending on my m50 swap.

[So Live]

For those inquiring, Ill do a compression test tomoro afternoon too.

[So Live]

Cold comp test:
1- 130
2- 145
3- 110
4- 130
5- 135
5- 145

Im going to try to determine where that 110 is coming from tomrow. I cant stress enough that this motor ran very well. It didnt burn oil or do anything funny. It pulled great for what it is. Its no s52 but you cant expect it to be.

[So Live]

Alright, so i did some fooling around with this thing today. Basically nothing helped. So my last resort was to put a cap and a half of oil in the #3 jug. The compression jumped right up to 130 which was nice. The more i tested it the more it went down. This leads me to beleive the low number is due to a block problem. If the oil didnt help i would have said its a head or head gasket problem but its not.

For whatever its worth, this thing ran great before it was pulled.

[Jesse30]

this would be good for a stroker project. hmmm...