WTB: M20B25 cylinder head in good condition

[arch4ngel]

Looking for a good condition cylinder head for a 1989 325i vert.
Must be in good condition, preferably rebuilt.
The head need to be straight, and the gasket surface must be without scratches.
Looking to spend less than $450 if possible.

[Ben Carufel]

Sent PM.

[Unearth078]

I have one. Its clean as hell but don't have any info on it. If its as maintained as well as the car its coming out of, should be grade A.

[arch4ngel]

I have one. Its clean as hell but don't have any info on it. If its as maintained as well as the car its coming out of, should be grade A.

Did you note how many miles the car had on it when the head was pulled?
Have you checked the head to make sure it's straight?
How much are you looking for?

All PMs replied to.

[wickedE30]

Pm sent.

[lifeiskaos]

i have a head that has not been run since it was rebuilt. all seals/gasket replaced, valve stem seals replaced, and it was resurfaced. i have the receipts and will include them. over $400 of work into the head... i'd be willing to meet you half way. i'd like to see $300 for it.

only picture i have on the left:

[arch4ngel]

i have a head that has not been run since it was rebuilt. all seals/gasket replaced, valve stem seals replaced, and it was resurfaced. i have the receipts and will include them. over $400 of work into the head... i'd be willing to meet you half way. i'd like to see $300 for it.

only picture i have on the left:

Sounds like a good deal.
PM sent.

[lifeiskaos]

nice to meet you! pleasure doing business :)

[arch4ngel]

Nice meeting you too.
Mary said thanks a million for helping get her car running again :up: