I need the following parts for a plastic bumper car.
1. Driver side rear bumper trim.
2. Passenger front yellow turn signal lens.
3. Coolant level sensor.
4. Plastic vacuum line elbow that connects the brake booster to the intake manifold.
5. Shift boot and knob and that little rubber seal that goes over the hole where the shifter comes through the trans tunnel.
6. If you're local and happen to have 2-4 bottle caps with decent tires. (Just because it would be easier than dismounting my snows and getting new tires)
Let me know here or PM what you've got and how much shipped to 53713. Thanks.
If you have any of this and happen to need an engine related part, I may well have it. I have a complete spare engine sitting in the garage, everything from stock location/design K&N direct fit air filter - oil cooler.
1. Driver side rear bumper trim.
2. Passenger front yellow turn signal lens.
3. Coolant level sensor.
4. Plastic vacuum line elbow that connects the brake booster to the intake manifold.
5. Shift boot and knob and that little rubber seal that goes over the hole where the shifter comes through the trans tunnel.
6. If you're local and happen to have 2-4 bottle caps with decent tires. (Just because it would be easier than dismounting my snows and getting new tires)
Let me know here or PM what you've got and how much shipped to 53713. Thanks.
If you have any of this and happen to need an engine related part, I may well have it. I have a complete spare engine sitting in the garage, everything from stock location/design K&N direct fit air filter - oil cooler.
Comment